Wiring harness choices as follows:
Basic unterminated:
No frills - power, crank sensor & coil pack only
No frills - power, crank sensor & coil pack only
Complete unterminated:
Includes wires for load sensor, rev counter and shift light. Terminals included for optional output and switchable maps.
Includes wires for load sensor, rev counter and shift light. Terminals included for optional output and switchable maps.
Fully built (Type 1):
Suit Zetec coil pack and Zetec crank sensor. Comes with matching male/female connectors for load sensor input
Suit Zetec coil pack and Zetec crank sensor. Comes with matching male/female connectors for load sensor input
Fully built (Type 2):
Suit Zetec coil pack and Vauxhall 3-pin crank sensor. Comes with matching male/female connectors for load sensor input
Suit Zetec coil pack and Vauxhall 3-pin crank sensor. Comes with matching male/female connectors for load sensor input
Fully built (Type 3):
Suit Zetec coil pack and Vauxhall 2-pin crank sensor. Comes with matching male/female connectors for load sensor input
Suit Zetec coil pack and Vauxhall 2-pin crank sensor. Comes with matching male/female connectors for load sensor input
Fully built (Other):
We can build a loom to suit any application; buy online here, then send us an email with your requirements
We can build a loom to suit any application; buy online here, then send us an email with your requirements

I'm pleased to report that the Canems ignition unit is running very well on our 2 ltr Zetec, fitted with Bogg manifold and ZX6R bike carbs, fitted into our Pop 100e.
We run TPS as you know, so had to write in the rest of the 3D map and actually change a few settings as well, back to our own field tested values.
It was easy, the instructions were clear and precise ( and what a change not to have to rely on getting a Bluetooth connection ! ).
So, take a pat on the back, you have a very good, user friendly product ( but you already know that, anyway ).

I can't thank the guys at Canems enough. I've had a missfire on my zetec for around 8 months. I've been though everything in the carbs an ignition system, spent countless hours and money chasing my tail. I finally decided to bite the bullet, and buy the Canems kit to see if it was a problem with my existing ecu from another manufacturer. The Canems ECU plugged in and solved the problem immediately. Not only that the car runs better around, is keener to start and idles better. As well as The TPS calibration working properly.
It's completely transformed my car. In the last 500 ISH miles it's not missed,coughed, spluttered or back popped through the carb once.
Best Regards @zephyr_speedshop

All in and fired right up! Well impressed so far. Software is good and stable, revs nice and idles well. I reused the existing [other ECU supplier] supplied loom, unpinned, and repinned to suit. Can't wait til I can give it a run of Friday now, after checking the ignition timing of course.
Thanks for the info and help!
